Garage door won't close: sensor repair in Bronxville

A garage door that refuses to close is annoying, but it is the safety system doing its job.

Call (914) 247-4562

In short

A garage door that won't close from the remote is most often a sensor problem, not a broken door. In Bronxville, a technician checks the photo-eyes and wiring, resets the travel and force, and confirms the door reverses on contact before leaving. Don't bypass the sensors in the meantime.

Chain-drive garage door opener under exposed rafters

Doors that won't close in Bronxville

Bronxville is one square mile of hills, and in Lawrence Park and Lawrence Park West the houses climb steep, winding lanes laid out in the 1890s. Garages there are often cut into the slope beneath the house or squeezed beside it, small, damp and stone-walled, and sensors are bolted to masonry where they are hard to adjust. In Cedar Knolls and on the east side, Tudors and Colonials have narrow garages built for smaller cars. Near the village center, space is tight enough that garages double as storage. Steep driveways send rainwater and leaves straight to the threshold, right where the sensors sit.

What it means when the door won't go down

Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.

  • Blinking sensor light: the eyes are out of line or one lens is dirty.
  • Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
  • Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.

Three safe checks before you call

  1. Look at the small lights on both sensors. Each should be on and steady.
  2. Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
  3. Gently turn the blinking sensor until its light goes steady, then try the remote again.

If that doesn't do it, stop there. Don't tape the sensors together or bypass them.

How the repair is done

The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.

Around Bronxville

  • Cedar Knolls: A historic district of about 140 homes, also in Yonkers with a Bronxville address.
  • East side: Toward Tuckahoe and Eastchester, with Tudors and colonials on slightly larger lots.

See the full Bronxville service area.

Garage door won't budge? Call first, force it never.

A door with a broken spring or cable can drop suddenly. Leave it closed, keep clear, and call. We'll tell you whether it's safe to use and get a technician scheduled.

Call (914) 247-4562
Call (914) 247-4562